今天重装了vmware后，再次使用原来的Ubuntu7.10文件，找不到网络连接。
web@Ubuntu8:~$ ifconfigeth1 Link encap:Ethernet HWaddr 00:0C:29:ED:F3:C2 inet addr:0 Bcast:0 Mask:0Interrupt:16 Base address:0x2000
lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0inet6 addr: ::1/128 Scope:HostUP LOOPBACK RUNNING MTU:16436 Metric:1RX packets:0 errors:0 dropped:0 overruns:0 frame:0TX packets:0 errors:0 dropped:0 overruns:0 carrier:0collisions:0 txqueuelen:0 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
sudo vim /etc/network/interfaces# This file describes the network interfaces available on your system# and how to activate them. For more information, see interfaces(5).
# The loopback network interfaceauto loiface lo inet loopback
# The primary network interfaceauto eth0iface eth0 inet dhcp原来是新旧vmware的网卡不一样，将eth0改为eth1，重启网络sudo /etc/init.d/networking restart一切OK了
顺便讲一下/etc/network/interfaces如果是配置eth为静态IP（比如192.168.1.1）并且指定网关（如192.168.1.254），那么如此配置：auth eth0iface eth0 inet staticaddress 192.168.1.1netmask 255.255.255.0gateway 192.168.1.254如果是手动指定IP并且还需要访问互联网，比如wget下载，，那么还需要设置DNS：$sudo pico /etc/resolv.conf向这里添加配置内容：nameserver xxx.xxx.xxx.xxx保存即可。
世界会向那些有目标和远见的人让路(冯两努–香港着名推销商
