有的时候当你用RAID从其他机器克隆一个系统到新硬盘中时，会出现新网卡不是从eth0开始，如果你想修改网卡从eth0开始，可以编辑"/etc/udev/rules.d/70-persistent-net.rules",如下
HostA:/dev # vi /etc/udev/rules.d/70-persistent-net.rules
# This file was automatically generated by the /lib/udev/write_net_rules# program run by the persistent-net-generator.rules rules file.## You can modify it, as long as you keep each rule on a single line.
# PCI device 0x15ad:0x07b0 (vmxnet3)SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="00:50:56:a2:00:71", ATTR{type}=="1", KERNEL=="eth*", NAME="eth1"
把eth1，改为eth0,保存后重启。
重启后发现机器ping不通，想办法连接到console，ifconfig发现无eth1
lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:98 errors:0 dropped:0 overruns:0 frame:0 TX packets:98 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:9059 (8.8 Kb) TX bytes:9059 (8.8 Kb)
原来刚才修改完文件后并未修改eth config文件。
HostA:~ # cd /etc/sysconfig/network/HostA:/etc/sysconfig/network # mv ifcfg-eth1 ifcfg-eth0HostA:/etc/sysconfig/network # /etc/init.d/network restarteth0 Link encap:Ethernet HWaddr 00:50:56:A2:00:71 inet addr:192.168.1.x Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: fe80::250:56ff:fea2:71/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:5576 errors:0 dropped:0 overruns:0 frame:0 TX packets:553 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:501494 (489.7 Kb) TX bytes:204124 (199.3 Kb)
OK,网络设定已经完成，但是发现还是无法ping通该主机，但是可以从主机内ping通网关。原来还需要修改routes
HostA:/etc/sysconfig/network # vi routesdefault 192.168.1.254 – eth1
把eth1修改为eth0。保存，重启网络服务，ping通，搞定,收工
天涯第一号
原来和文字沾上边的孩子从来都是不快乐的，
